- #Kenwood tk 880 programming install
- #Kenwood tk 880 programming software
- #Kenwood tk 880 programming series
3Ĥ Programming the Pyramid 2016 Programming of the Pyramid 2016 base modem is done through the console interface. More programming instructions are available in the 2012/Merlin Service Manual. Chose the format to fit your application. There are three signaling format cho ices. From the Data pull down menu, select your Data Format in the Format Screen.
#Kenwood tk 880 programming software
Note: Console needs to match programming the 2016 Console Software Vehicle #: 100 ( ) Base #: 1 (1-4) PTT Delay: 0.5 S (.1-2.5) Retries: 3 (0-9) Trunking mobile Yes Sequential Status No ANI on mobile PTT No Enable Time Stamp No COR Polarity High On Air Polarity High I/O Pin 9 Output Mute Enable Turnking Mode if applicable. Vehicle # and Base # will vary with your application. From the Data pull down menu, under the System Data screen, program the unit as shown the figure below.
Start running the Pyramid 2012/Merlin programming software on your PC.
#Kenwood tk 880 programming install
If you have not already done so, install the programming software on to your PC by following the instructions in the 2012/Merlin service manual. Programming the Pyramid 2012/Merlin The mobile data terminal needs to be programmed to accommodate the polarities of signal that the Kenwood mobile will provide it. To get a copy of version 8050 firmware please contact your Kenwood dealer. Also, you will need a copy of the Pyramid 2012 programming software and FY-1 programming cable to program the Your TK-x80 radio MUST be programmed with firmware version 8050 or newer for mobile data applications.
#Kenwood tk 880 programming series
1 Programming Instructions for: Kenwood TK-880, 980, 981 W/ KCT-19 Option Connector For use with: Pyramid Communications Model 2012/2016/Merlin Revision D November 21,Ģ Introduction.3 Programming the Pyramid 2012/Merlin.3 Programming the Pyramid Programming the Kenwood TK-x80 Series Mobile.5 Radio Format.5 Programming Optional Features.5 Programming the Logic Signalling.6 Programming the Talk Group information for a 2012/Merlin MDT.6 Defining a Talk Group for Data Use.7 Programming the Talk Group information for a 2016 Base.8 Connecting the Pyramid to the Kenwood TK-x Connecting the 2012/Merlin MDT to the TK-x80 radio Jumper Settings in the 2012/Merlin Connecting the 2016 base to the TK-x80 radioģ Introduction Before you begin, you will need to have a copy of KPG-49D and programming cable available to program the mobile radio.
0 kommentar(er)
